Wednesday, October 3, 2007

Good News!

I heard back from Gammill today, and they are going to fabricate a new extended base plate for my machine based on the photos and measurements I gave them. So I will soon have one that fits...assuming my measurements were right lol.

There have been complaints about service and other issues on some of the lists. But I have to say, Whenever I have contacted Gammill with an issue, they have jumped on it and resolved it. So I guess my point is contact your machine company with's in their best interest to find a solution, and I'll bet they'll be happy to do it.


  1. glad that's all being worket out and you are happy with the service! Most people only post the bad experiences and not the good ones.

  2. I hope your measurements were correct too! I was paranoid when I got my Circle Lord that it wouldn't fit but Michael had a fudge factor built in and it was fine.

    Speaking of Circle Lord - when are you getting yours?

  3. It's great to hear about your terrific customer service with your company.

    Enjoy your weekend!


Thanks for visiting! I always enjoy your comments.

Note: Only a member of this blog may post a comment.